E-Series I/C

Take command of an air system by installing a ConservAIR Intermediate Control. A ConservAIR Intermediate Control (I/C) will:

  • stabilize the system pressure supplied to the production floor.
  • deliver only the amount of air necessary to perform the task.
  • satisfy peak demands utilizing air storage.
  • improve product quality and increase production efficiency.
  • save up to 50% or more of the required input horsepower.
  • reduce compressor wear and decrease expended energy.

    		•
    E-Series (Standard models)
    MODEL NO. MAX FLOW (SCFM)
    E3-2C2M2 1,000
    E3-2C2A2 1,000
    E3-2C2M2.5 1,500
    E3-2C2A2.5 1,500
    E3-3C2M3 2,250
    E3-3C2A3 2,250
    E4-4C2M3 3,000
    E4-4C2A3 3,000

     

    C-Series I/C

    C-Series
    The C-series I/C is custom designed to meet specific applications that cannot be satisfied with the standard models listed above.

    Features
  • Larger flow capacities above 3.000 SCFM.
  • Fully redundant pneumatic backup parallel
  • Special mounting.
  • Higher pressure ratings.
  • More sophisticated monitoring, annunciation and instrumentation.
  • Full PlD electronic conlrol authority
  • Direct computer interface.
  • Sequenced parallel configurations.
  • Additional control inputs.
    		•

    Particulate(Interceptor)

    Pneumatech's Particulate Filter uses an interceptor element which is absolute rated to 3 micrometers

    The interceptor element is a pleated, large area, high capacity, cellulose elemnt with porosity matched to the coalescer forprefiltering, or as an independent 3um instrument quality particulate filter.

    Pneumatech's Particulate Filter are perfect for eliminating desiccant dust after a regenerative compressed air dryer. they are also used as a prefilter to a coalescing filter and will help extend the life of a coalescing element. The smaller filters (1"and less) are often used as poit of use filters to help prevent pipe scale and oyher contaminants from damaging production tools and cylinders.

    Adsorber

    Pneumatech's Adsorber Filter is an ultra-fine grained, highly concentrated, activated carbon media filter used primarily for vapor and odor elimination. Adsorbers will act as a final polishing filter to remove final trace amounts of hydrocarbon contaminants and vapors (odors). They will remove virtually all contaminants present to 0.1um Absolute.